Botas impermeables Timberland Pro

Preguntas frecuentes

A waterproof boot uses a sealed membrane and sealed seams so water cannot work through the leather or the stitching. Water-resistant leather sheds rain and handles damp ground but wets through with sustained exposure. The distinction matters if you stand in water rather than walk through it, and it is stated in the product title.

The outsole is molded directly onto the upper under heat and pressure, creating a permanently sealed bond at the joint rather than a stitched or glued seam that can eventually admit water. It is the most watertight joint Timberland PRO builds. The trade is that the boot cannot be resoled, since there is no welt to unstitch.

High enough for the water you actually stand in, since the membrane protects only to the collar. A 6-inch handles wet ground and rain. If you work in standing water or deep mud, an 8-inch does considerably more for you than a better membrane on a short boot. See our Timberland PRO 8 inch range.

Usually sweat rather than leakage, particularly in warm weather when the membrane cannot breathe effectively. The other common cause is water coming in over the collar, which no membrane prevents. If the outer leather is soaking through, that is a worn water-repellent finish rather than a failed membrane, and it can be restored.

Yes. Membranes fail at seams and flex points over a few years of hard wear, and unlike an outsole they cannot be replaced. Treat waterproofing as a finite feature over the life of the boot. The outer repellent finish wears off much sooner and can be restored by cleaning and reapplying a treatment.

Yes, and the combination is standard for winter work since wet insulation stops working and snow melts against a warm boot. Insulation weight is stated in every product title where it applies. See our Timberland PRO insulated range.

No. Waterproofing sits between the leather and the lining and has nothing to do with the toe cap or the outsole ratings. A waterproof boot carries whatever ASTM ratings it was built and tested for, exactly as a non-waterproof version of the same model would.

Clean the dirt off regularly, since it clogs the outer material and stops moisture escaping, which causes clammy feet. Condition the leather every one to three months. Dry at room temperature away from direct heat, which damages both the leather and the membrane adhesives.

Botas impermeables Timberland Pro

Preguntas frecuentes

Vistos recientemente

Nuestras marcas principales

Preguntas frecuentes

What is the difference between waterproof and water-resistant?

How does Direct Attach construction help with water?

How high should a waterproof boot be?

Why do my waterproof boots feel wet inside?

Does waterproofing wear out?

Can waterproof boots also be insulated?

Does a waterproof membrane affect the safety rating?

How do you care for a waterproof leather boot?